TO nnnn-nn-nnn-nnInstruction BookwithParts ListTERMALINE® LOAD RESISTORMODEL 8833-300Bird Electronic Corporationnnnnnn-nn-n-nnnnJanuary 1, 1996© Copyr
Place the unit on its back, with the connector endup. This position prevents coolant spillage.Remove the clamping band by loosening the 10-32x 1-1/2 i
band for coolant leakage. If leakage is observed:Tighten the clamping screw if required. If the coolantcontinues to leak, proceed to step (b).Replace
5.9 Replacement Parts ListItemQuantityDescriptionPart Number11RF Load Resistor 8205-00221 Resistor Housing O-Ring Seal, (included in item1) 8110-03931
LIMITED WARRANTYAll products manufactured by Seller are warranted tobe free from defects in material and workmanship fora period of one (1) year, unle
SAFETY PRECAUTIONSThe following are general safety precautions that arenot necessarily related to any specific part or proce-dure and do not necessari
Table Of Contents1.Introduction5Purpose and Function5Description5RF Input5Coolant5Vent5Items Supplied5Specifications5Component Location6Installation7M
Introduction1.1 Purpose and FunctionThe Model 8833-300 Termaline Load Resistor isdesigned as a low reflection and nonradiating termi-nation for coaxia
1.8 Component LocationRefer to the following Outline Drawing, Figure- 1, fordimensions and component location.2.Installation2.1 MountingThe Model 8833
free standing or can be attached to a bench, etc.,Refer to Figure-1, Outline Drawing, for location of thetwo mounting brackets and four mounting holes
Note: Be sure that the knurled ring nut [A] is in place over the base plug [D] with the knurled endoutward (towards face).Screw on the cover ring [C].
istor housing mount furnishes a seal for the radiatoropening. A beveled flange retains the o-ring. Theo-ring is pressed against the radiator face by t
Commentaires sur ces manuels